How to set up the Reference Turntables from Fluance (RT82, RT83, RT84, RT85)
This video will take you through the setup of the new Reference Turntables from Fluance: RT82, RT83, RT84 and RT85.
We're here to show you how to install the platter, motor pulley, dust cover, cartridge, and counterweight, as well as how to balance the tonearm.
Reference Turntables are 4 models, which share the same plinth, but offer different stylus and platter options.
*NOTE* If you start the process over once the Anti Skate is set, reset the Anti Skate to "0".
1. Install the platter and motor pulley cap.
2. Lift the belt and place it over the motor pulley.
3. Place the counterweight on the back of the tonearm (with the numbers facing forward).
4. Install the headshell.
5. Install the hinges on the dust cover (use a soft surface to avoid scratches) and install the dust cover.
6. Place the included leveling bubble on the platter, and use the adjustable feet to make sure the turntable is level.
7. Remove the stylus protector and raise the cueing lever.
8. Position the tonearm over the platter
9. While holding the headshell, lower the cueing lever. DO NOT LET THE STYLUS TOUCH THE PLATTER.
10. With the cueing lever now lowered, turn the entire counterweight until the tonearm is balanced and floating horizontally when the headshell is released.
11. Set only the counterweight indicator ring to “0” on the center line while keeping the tonearm balanced, then lock the tonearm on the tonearm rest.
12. Determine the recommended tracking force for your cartridge. Rotate the entire counterweight counterclockwise until the indicator ring is set to the correct value on the center line. For OM10, the tracking force is 1.5g. For 2M Red and 2M Blue, it is 1.8g
13. Set the anti-skating control value to match the recommended tracking force.